This is a fun bracelet with a lot of color and fun!
Starburst Loom Bracelet Supplies Needed:
- 33 Bands for your base color
- 6 bands each in 6 different colors
- 1 finishing band
- 1 C Clip
- Loom
- Hook
How to Make a Starburst Loom Bracelet Directions:
You want to load the loom by starting the band at the bottom, load the left column. When you reach the top, start again at the bottom and load up the right column.
Then create the starbursts with the six bands each.
Make certain you go exactly like shown here:
When you are done, add one double-looped band on the single peg in the center of each of the six starbursts; Then add one to the top middle peg (bands 63-69).
Turn the loom so the arrow faces down.
Push your hook down into the groove of the bottom middle peg and hook the first band beneath the double-looped band. Loop the band to the peg directly above it.
Next, push your hook down into the groove of the center of the first starburst. Hook the band that is stretched from the center of the starburst down to the right.
Make sure you push your hook down through the base color double-loop band!
Loop the band you hooked to the peg to the bottom right, the peg it came from. This first band is trecky…you can do it!
Push your hook into the groove of the center peg of the starburst adn hook the next band down (the one that is stretched from the center of the starurst up to the right. Loop it to the peg in the upper right.
Move counterclockwise and loop the remaining bands in the starburst, just three more, just like you looped the first two. When you are done, you’ll have a big loop around the middle peg, like this:
You’re on a roll.
Repeat the pattern for the rest of the starbursts.
Remember, to ALWAYS push your hook down into the groove!
Once all the starbursts have been done, you’ll want to take the bottom middle peg and loop the second from bottom band up through the groove and onto the peg it came from, to the upper left.
Hook the very bottom band on the peg you just looped to and loop it to the peg immediately above it.
KEEP pushing your hook down in the groove as you go!
Repeat all the way up the loom, looping each border band to the peg above it.
Loop the final band from the top left peg onto the middle peg.
Back to the bottom middle peg, repeat the pattern to loop the entire right column, including looping the top right band to the top middle peg.
Finally, secure bands on the top peg with a slip knot. Pull the bracelet off the loom and enjoy!